Electrical Safety - Assessment Test

Electrical Safety - Assessment Test

Test your current knowledge of Electrical Safety through this short assessment quiz.

After completion, feel free to share this quiz with your friends or co-workers and see who scores the highest.

We also invite you to view our selection of Electrical Safety & Maintenance courses available to help you really take your electrical experience & skills to the next level.

First Name*
Last Name*
Company*
Phone*
Mobile
Email*
One of the three generally recognized hazards of electrical work is____.



Gloves used for electrical protection must be electrically tested every:



Electrical safety equipment should be visually inspected_______.



OSHA 29 CFR 1910.147 is not adequate for electrical lockout.



Which is the "Can't Let Go" range of current flow?



Which organization is NOT a source of regulations or standards?



Which is not a main factor in accidents?



What is the voltage rating on a Class 00 rubber insulating glove?



Unqualified persons may not approach an overhead line energized at 4,160v closer than_____.



NFPA 70E requires the testing of a volt meter before and after a voltage test on voltage above _______.



Which Subpart of OSHA 29 CFR1910 addresses electrical safety?



Which NFPA standard provides safe work procedures?



Work performed on an electrical system within reaching distance of energized components is________work.



NFPA 70 defines Work Space Condition _______ as having live parts on one side and grounded parts on the other side.



The secondary of a current transformer must never be ____________ while energized.



Rod and pipe grounding electrodes must be at least _____feet in length.



The minimum allowable work space around electrical equipment is ________ inches wide.



The grounded circuit conductor (neutral) should be bonded to the equipment ground on the _______side of the service.



When installing or removing breakers from a cubicle, the breaker must be in the __________ condition.



Which hazard/s can be present around a bank of batteries?